Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • November 20, 2016 at 1:29 am #1959
    Doug, NO1D
    User

    Is there errata/recommendations for interfacing the v1.11 board with an oDroid C1?

    The HW 40 pin connector according to schematic is for the rPI and noticed a pin not in sync with the oDroid C1. Relay 1 pin 38 is connected to a 1.8v supply on the oDroid C1. Curious if anyone has interfaced the board with an oDroid C1.

    I am hoping I can remap relay 1 to another unused GPIO port and make appropriate change in software.

    Doug – NO1D

    December 2, 2016 at 2:40 pm #1961
    Richard, N4CNR
    Forum Moderator

    there is a version of the board for the c1 you can order. you have to contact Juan F8ASB he has the board with the pin out. I also have a small board now that is for pi/odroid

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.